Norm

NEN-EN-ISO 1133:2005 en

Kunststoffen - Bepaling van de smeltindex op basis van massa (MFR) en volume (MVR) van thermoplasten

73,12

Over deze norm

Status Definitief
Aantal pagina's 16
Commissie Kunststoffen
Gepubliceerd op 01-06-2005
Taal Engels
This International Standard specifies two procedures for the determination of the melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastic materials under specified conditions of temperature and load. Procedure A is a mass-measurement method. Procedure B is a displacement-measurement method. Normally, the test conditions for measurement of melt flow rate are specified in the material standard with a reference to this International Standard. The test conditions normally used for thermoplastics are listed in Annexes A and B. The MVR will be found particularly useful when comparing materials of different filler content and when comparing filled with unfilled thermoplastics. The MFR can be determined from MVR measurements provided the melt density at the test temperature and pressure is known. These methods are in principle also applicable to thermoplastics for which the rheological behaviour is affected during the measurement by phenomena such as hydrolysis, condensation or crosslinking, but only if the effect is limited in extent and only if the repeatability and reproducibility are within an acceptable range. For materials which show significantly affected rheological behaviour during testing, these methods are not appropriate. In such cases, the use of the viscosity number in dilute solution, determined in accordance with the relevant part of ISO 1628, is recommended for characterization purposes.

Details

ICS-code 83.080.20
Nederlandse titel Kunststoffen - Bepaling van de smeltindex op basis van massa (MFR) en volume (MVR) van thermoplasten
Engelse titel Plastics - Determination of melt mass-flow rate (MFR) and the melt volume-flow rate (MVR) of thermoplastics
Vervangt
Wordt vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen