Norm

NEN-EN-ISO 12215-5:2019 en

Kleine vaartuigen - Rompconstructie en verbanddelen - Deel 5: Ontwerpdrukken  voor enkelromps vaartuigen, ontwerpspanningen, vaststelling van de verbanddelen

181,14 219,18 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 126
Commissie Jachtbouw
Gepubliceerd op 01-06-2019
Taal Engels
NEN-EN-ISO 12215-5 defines the dimensions, design local pressures, mechanical properties and design stresses for the scantlings determination of monohull small craft with a hull length (LH) or a load line length (see NOTE 1) of up to 24 m. It considers all parts of the craft that are assumed to be watertight or weathertight when assessing stability, freeboard and buoyancy in accordance with ISO 12217. The main core of this document determines the local design pressures and stresses for monohulls and details the possible scantlings methods derived from these pressures and stresses, both for monohulls and multihulls (see NOTE 2). The assessment process requires, where relevant, the application of Annexes. This document is applicable to small craft, in intact condition, of the two following types: - recreational craft, including recreational charter vessels; - small commercial craft and workboats, see Clause 12 and Annex J. It is not applicable to racing craft designed only for professional racing. This document is applicable to the structures supporting windows, portlights, hatches, deadlights, and doors. For the complete scantlings of the craft, this document is intended to be used with ISO 12215-8 for rudders, ISO 12215-9 for appendages and ISO 12215-10 for rig loads and rig attachments. This document covers small craft built from the following materials: - fibre-reinforced plastics, either in single skin or sandwich construction; - aluminium or steel alloys; - glued wood or plywood (single skin or sandwich), excluding traditional wood construction; - non-reinforced plastics for craft with a hull length less than 6 m (see Annex D). Throughout this document, unless otherwise specified, dimensions are in (m), areas in (m2), masses in (kg), forces in (N), moments in (N.m), pressures in kN/m2 (1 kN/m2 = 1 kPa), stresses and elastic modulus in N/mm2 (1 N/mm2 = 1 Mpa). Max(a;b;c) means that the required value is the maximum of a, b, and c; and min(d;e;f) means that the required value is the minimum of d, e, and f.

Details

ICS-code 47.020.10
47.080
Nederlandse titel Kleine vaartuigen - Rompconstructie en verbanddelen - Deel 5: Ontwerpdrukken  voor enkelromps vaartuigen, ontwerpspanningen, vaststelling van de verbanddelen
Engelse titel Small craft - Hull construction and scantlings - Part 5: Design pressures for monohulls, design stresses, scantlings determination
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen