Norm

NEN-EN-ISO 14405-2:2010 Ontw. en

Geometrische productspecificaties (GPS) - Indicatie van afmetingen en toleranties - Deel 2: Afmetingen anders dan lengtematen

  • Deze norm is ingetrokken sinds 13-12-2011

31,83

Over deze norm

Status Ingetrokken
Aantal pagina's 30
Commissie Productgeometrie
Gepubliceerd op 01-04-2010
Taal Engels
This part of ISO 14405 defines the use of geometrical tolerances for dimensions that are not linear sizes to avoid the ambiguity that the use of ± tolerances on this type of dimensions causes. Both linear and angular dimensions, except size, are covered by this document. Dimensional tolerancing can be indicated by ± tolerancing or geometrical tolerancing. The ambiguity caused by using ± tolerances for dimensions other than linear sizes (for individual tolerances and general tolerances according to, e.g. ISO 2768-1 and ISO 8062-3) is explained in Annex A. For indications of size tolerances, see: - ISO 14405-1 for linear size; - ISO 2538 for wedges; - ISO 3040 for cones. The figures, as shown in this part of ISO 14405, merely illustrate the text and are not intended to reflect actual usage. The figures are consequently simplified to indicate only the relevant principles.

Details

ICS-code 17.040.10
Nederlandse titel Geometrische productspecificaties (GPS) - Indicatie van afmetingen en toleranties - Deel 2: Afmetingen anders dan lengtematen
Engelse titel Geometrical product specifications (GPS) - Dimensional tolerancing - Part 2: Dimensions other than linear sizes
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen