Norm

NEN-EN-ISO 15252-3:1999 en

Kunststoffen - Pers-, spuitgiet- en extrusiematerialen van vrij-stromende epoxyharsen (EP-PMCs) - Deel 3: Eisen voor geselecteerde EP-gietmaterialen

31,57

Over deze norm

Status Definitief
Aantal pagina's 6
Commissie Kunststoffen
Gepubliceerd op 01-12-1999
Taal Engels
Specifies the requirements for the physical and chemical properties of epoxy powder moulding compounds (EP-PMCs) and compression- or injection- moulded test specimens produced from them. It is limited to those powder moulding compounds whose composition and properties are significantly different. It is further limited to those moulding compounds which are of general technical and/or economic importance.

Details

ICS-code 83.080.10
Nederlandse titel Kunststoffen - Pers-, spuitgiet- en extrusiematerialen van vrij-stromende epoxyharsen (EP-PMCs) - Deel 3: Eisen voor geselecteerde EP-gietmaterialen
Engelse titel Plastics - Epoxy powder moulding compounds (EP-PMCs) - Part 3: Requirements for selected moulding compounds
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen