Norm

NEN-EN-ISO 15530-3:2011 en

Geometrische productspecificaties (GPS) - Coördinaten-meetmachines (CMM): Techniek voor bepaling van de meetonzekerheid - Deel 3: Gebruik van gekalibreerde werkstukken en standaarden

79,70

Over deze norm

Status Definitief
Aantal pagina's 18
Commissie Productgeometrie
Gepubliceerd op 01-11-2011
Taal Engels
This part of ISO 15530 specifies the evaluation of measurement uncertainty for results of measurements obtained by a CMM (coordinate measuring machine) and by using calibrated workpieces or measurement standards. It provides an experimental technique for simplifying the uncertainty evaluation of CMM measurements, whose approach (substitution measurements) leads to measurements being carried out in the same way as actual measurements, but with calibrated workpieces of similar dimension and geometry instead of the unknown workpieces to be measured. Non-substitution measurements on CMMs are also covered, as are the requirements of the uncertainty evaluation procedure, the measurement equipment needed, and the reverification and interim check of the measurement uncertainty.

Details

ICS-code 17.040.30
Nederlandse titel Geometrische productspecificaties (GPS) - Coördinaten-meetmachines (CMM): Techniek voor bepaling van de meetonzekerheid - Deel 3: Gebruik van gekalibreerde werkstukken en standaarden
Engelse titel Geometrical product specifications (GPS) - Coordinate measuring machines (CMM): Technique for determining the uncertainty of measurement - Part 3: Use of calibrated workpieces or measurement standards
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen