Norm

NEN-EN-ISO 15614-13:2010 Ontw. en

Specificate en kwalificatie van lasmethoden voor metalen - Lasmethodebeproeving - Deel 13: Weerstand stomp- en flashlassen

  • Deze norm is ingetrokken sinds 16-07-2012

17,55

Over deze norm

Status Ingetrokken
Aantal pagina's 0
Commissie Lassen en verwante processen
Gepubliceerd op 01-11-2010
Taal Engels
This standard specifies the tests which may be used for qualification of welding procedure specifications. This standard is a part of a series of standards. Details of this series are given in prEN ISO 15607, Annex A. It defines the conditions for carrying out tests and the limits of validity of an qualified welding procedure for all practical welding operations covered by this standard. The tests required to qualify the procedure for a particular component/assembly depend on the performance and quality requirements of the component/assembly and should be defined in the specification. The tests should be carried out in accordance with this standard, unless more severe tests are specified by the relevant application standard or specification, when these should apply. This standard applies to resistance butt welding and flash welding of metallic materials, e. g. with solids, tubular, flat, round cross section. The basic principles of this standard may be applied to other resistance welding processes when this is specified in the specification.

Details

ICS-code 25.160.10
Nederlandse titel Specificate en kwalificatie van lasmethoden voor metalen - Lasmethodebeproeving - Deel 13: Weerstand stomp- en flashlassen
Engelse titel Specification and qualification of welding procedures for metallic materials - Welding procedure test - Part 13: Resistance butt (upset) and flash welding
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen