Norm

NEN-EN-ISO 16841:2012 Ontw. en

Staalkabels - Trekogen voor kabelinstallatie - Types en minimale eisen

  • Deze norm is ingetrokken sinds 12-03-2014

25,62

Over deze norm

Status Ingetrokken
Aantal pagina's 15
Commissie Staalkabels
Gepubliceerd op 01-09-2012
Taal Engels
This International Standard identifies the different types of pulling eyes that are prepared at, or attached to, asteel wire rope end for connection to another rope when installing a new rope or re-reeving an existing ropeon a machine.This International Standard also specifies the minimum requirements for pulling eyes, including their geometry,strength, maximum line pull to which the pulling eye should be subjected and information for use to beprovided by the manufacturer.The pulling eyes covered by this International Standard are not intended to be subject to a load when themachine performs a service operation.This International Standard applies to those pulling eyes that are prepared at, or attached to, ends of steelwire ropes conforming to ISO 2408 and ISO 10425.This International Standard does not apply to steel wire ropes with fibre cores.This International Standard does not cover those separate end connection accessories that slide over the endof a rope and comprise an eye and tubular type braided rope, often referred to as a ‘wire rope stocking’ or‘cable sock’.

Details

ICS-code 77.140.65
Nederlandse titel Staalkabels - Trekogen voor kabelinstallatie - Types en minimale eisen
Engelse titel Steel wire ropes - Pulling eyes for rope installation - Types and minimum requirements
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen