Norm

NEN-EN-ISO 17662:2016 en

Lassen - Kalibratie, verificatie en validatie van uitrusting die gebruikt wordt bij het lassen, inclusief aanvullende werkzaamheden

124,99

Over deze norm

Status Definitief
Aantal pagina's 29
Commissie Lassen en verwante processen
Gepubliceerd op 01-04-2016
Taal Engels
NEN-EN-SO 17662 specifies requirements for calibration, verification and validation of equipment used for - control of process variables during fabrication, and - control of the properties of equipment used for welding or welding allied processes where the resulting output cannot be readily or economically documented by subsequent monitoring, inspection and testing. This involves process variables influencing the fitness-for-purpose and in particular the safety of the fabricated product. NOTE 1 This International Standard is based on the lists of process variables stated in International Standards for specification of welding procedures, in particular, but not exclusively in the ISO 15609- series. Future revisions of these International Standards can result in addition or deletion of parameters considered necessary to specify. Some guidance is, in addition, given in Annex B as regards requirements for calibration; verification and validation as part of acceptance testing of equipment used for welding or allied processes. Requirements to calibrate, verify and validate as part of inspection, testing, non-destructive testing or measuring of final welded products performed in order to verify confirm product compliance are outside the scope of the present International Standard. The subject of this International Standard is limited to calibration, verification and validation of equipment after installation, as part of the workshops’ and site operations for maintenance and/or operation. It needs to be stressed that this International Standard has nothing to do with manufacture and installation of equipment for welding. Requirements for new equipment are formulated in directives and product codes (standards), as necessary. Annex C provides information when other parties are involved in calibration, verification and validation activities.

Details

ICS-code 25.160.30
Nederlandse titel Lassen - Kalibratie, verificatie en validatie van uitrusting die gebruikt wordt bij het lassen, inclusief aanvullende werkzaamheden
Engelse titel Welding - Calibration, verification and validation of equipment used for welding, including ancillary activities
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen