NEN-EN-ISO 2818:2019 en

Kunststoffen - Vervaardiging van proefstukken door machinale bewerking

88,37 96,32 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 16
Commissie Kunststoffen
Gepubliceerd op 01-02-2019
Taal Engels
NEN-EN-ISO 2818 establishes the general principles and procedures to be followed when machining and notching test specimens from compression-moulded and injection-moulded plastics, extruded sheets, plates and partially finished or wholly finished products. In order to establish a basis for reproducible machining and notching conditions, the following general standardized conditions are applied. It is assumed, however, that the exact procedures used are selected or specified by the relevant material specification or by the standards on the particular test methods. If sufficiently detailed procedures are not thus specified, the interested parties agree upon the conditions to be used.


ICS-code 83.080
Nederlandse titel Kunststoffen - Vervaardiging van proefstukken door machinale bewerking
Engelse titel Plastics - Preparation of test specimens by machining



Ga naar winkelwagen