Norm

NEN-EN-ISO 28927-6:2008 Ontw. en

Draagbare handgereedschappen - Beproevingsmethoden voor de evaluatie van de trillingsemissie - Deel 6: Stampers

  • Deze norm is ingetrokken sinds 13-01-2010

31,83

Over deze norm

Status Ingetrokken
Aantal pagina's 24
Gepubliceerd op 01-04-2008
Taal Engels
This part of ISO 28927 specifies a laboratory method for measuring hand-transmitted vibration emission at the handles of rammers. It is a type-test procedure for establishing the magnitude of vibration in the gripping areas of the tools. This part of ISO 28927 applies to rammers, back-fill rammers, pawing rammers, sand rammers and stampers intended for use in foundries, on building sites, etc. with for example butts or peens made of cast iron or rubber used for ramming of casting sand or stamping work. The power tools covered by this part of ISO 28927 may be pneumatically driven, or driven by other means. Typical tools are illustrated in figure 1-2. This part of ISO 28927 applies to the tools mentioned in clause 5. It is intended that the results can be used to compare different models of the same type of power tool.

Details

ICS-code 13.160
25.140.10
Nederlandse titel Draagbare handgereedschappen - Beproevingsmethoden voor de evaluatie van de trillingsemissie - Deel 6: Stampers
Engelse titel Hand-held portable power tools - Test methods for evaluation of vibration emission - Part 6: Rammers
Vervangt
Vervangen door
Normatieve verwijzingen
  • 2006/42/EG, Machines

Winkelwagen

Subtotaal:

Ga naar winkelwagen