Norm

NEN-EN-ISO 2897-2:1999 en

Kunststoffen - Pers-, spuitgiet- en extrusiematerialen van slagvast polystyreen (PS-I) - Deel 2: Bereiding van proefstukken en bepaling van eigenschappen

  • Deze norm is ingetrokken sinds 30-06-2004

31,57

Over deze norm

Status Ingetrokken
Aantal pagina's 5
Commissie Kunststoffen
Gepubliceerd op 01-05-1999
Taal Engels
Specifies procedures for moulding specimens of impact-resistant polystyrenes in a specified state and methods for measuring their properties. Any property listed in Part 2 and referred to in combination with Part 1 shall be determined by the method referred to in Part 2. No figures are quoted for these properties. Those required for the designation of impact-resistant polystyrenes are given in ISO 2897-1. Other properties shall be determined by the appropriate methods referred to in this International Standard and values may be obtained from manufactures literature. They can be directly compared if the procedures described herein for preparing the test specimens and for determining the properties are followed.

Details

ICS-code 83.080.20
Nederlandse titel Kunststoffen - Pers-, spuitgiet- en extrusiematerialen van slagvast polystyreen (PS-I) - Deel 2: Bereiding van proefstukken en bepaling van eigenschappen
Engelse titel Plastics - Impact-resistant polystyrene (PS-I) moulding and extrusion materials - Part 2: Preparation of test specimens and determination of properties
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen