Norm

NEN-EN-ISO 3167:2003 en

Kunststoffen - Proefstukken voor meer doeleinden

  • Deze norm is ingetrokken sinds 20-08-2014

48,19

Over deze norm

Status Ingetrokken
Aantal pagina's 9
Commissie Kunststoffen
Gepubliceerd op 01-08-2003
Taal Engels
This International Standard specifies requirements relating to multipurpose test specimens for plastic moulding materials intended for processing by injection or direct compression moulding. Specimens of types A and B are tensile test specimens from which, with simple machining, specimens for a variety of other tests can be taken (see annex A). Because they have such wide utility, these tensile specimens are referred to in this International Standard as multipurpose test specimens. The principal advantage of a multipurpose test specimen is that it allows all the test methods mentioned in annex A to be carried out on the basis of comparable mouldings. Consequently, the properties measured are coherent as all are measured with specimens in the same state. In other words, it can be expected that test results for a given set of specimens will not vary appreciably due to unintentionally different moulding conditions. On the other hand, if desired, the influence of moulding conditions and/or different states of the specimens can be assessed without difficulty for all of the properties measured.

Details

ICS-code 83.080.01
Nederlandse titel Kunststoffen - Proefstukken voor meer doeleinden
Engelse titel Plastics - Multipurpose-test specimens
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen