Norm

NEN-EN-ISO 4064-1:2017 en

Watermeters bestemd voor koud en warm drinkwater - Deel 1: Metrologische en technische eisen

106,87

Over deze norm

Status Definitief
Aantal pagina's 26
Commissie Debiet- en hoeveelheidsmeting
Gepubliceerd op 01-06-2017
Taal Engels
NEN-EN-ISO 4064-1 applies to water meters used to meter the volume of cold potable water and hot water flowing through a fully charged, closed conduit. These water meters incorporate devices which indicate the integrated volume. This part of ISO 4064 specifies technical characteristics and pressure loss requirements for meters for cold potable water and hot water. It applies to water meters which can withstand: a) a maximum admissible pressure (MAP) equal to at least 1 MPa1) [0,6 MPa for meters for use with pipe nominal diameters (DNs) ≥500 mm]; b) a maximum admissible temperature (MAT) for cold potable water meters of 30 °C; c) a MAT for hot water meters of up to 180 °C, depending on class. In addition to meters based on mechanical principles, this part of ISO 4064 also applies to water meters based on electrical or electronic principles, and to water meters based on mechanical principles incorporating electronic devices, used to meter the volume flow of hot water and cold potable water. It also applies to electronic ancillary devices. As a rule ancillary devices are optional. However, national or international regulations may make some ancillary devices mandatory in relation to the utilization of the water meter.

Details

ICS-code 91.140.60
Nederlandse titel Watermeters bestemd voor koud en warm drinkwater - Deel 1: Metrologische en technische eisen
Engelse titel Water meters for cold potable water and hot water - Part 1: Metrological and technical requirements
Vervangt
Normatieve verwijzingen
  • 2014/32/EU,

Winkelwagen

Subtotaal:

Ga naar winkelwagen