Norm

NEN-EN-ISO 4499-2:2010 en

Hardmetalen - Metallografische bepaling van de microstructuur - Deel 2: Meting van de WC korrelgrootte

79,70

Over deze norm

Status Definitief
Aantal pagina's 17
Commissie Metalen algemeen
Gepubliceerd op 01-06-2010
Taal Engels
This part of ISO 4499 gives guidelines for the measurement of hardmetal grain size by metallographic techniques only using optical or electron microscopy. It is intended for sintered WC/Co hardmetals (also called cemented carbides or cermets) containing primarily WC as the hard phase. It is also intended for measuring the grain size and distribution by the linear-intercept technique. This part of ISO 4499 essentially covers four main topics: - calibration of microscopes, to underpin the accuracy of measurements; - linear analysis techniques, to acquire sufficient statistically meaningful data; - analysis methods, to calculate representative average values; - reporting, to comply with modern quality requirements. The part of ISO 4499 is supported by a measurement case study to illustrate the recommended techniques (see Annex A). Measurements of coercivity are sometimes used for grain-size measurement, but this current guide is concerned only with a metallographic measurement method. It is also written for sintered hardmetals and not for characterising powders. However, the method could, in principle, be used for measuring the average size of powders that are suitably mounted and sectioned.

Details

ICS-code 77.040.99
77.160
Nederlandse titel Hardmetalen - Metallografische bepaling van de microstructuur - Deel 2: Meting van de WC korrelgrootte
Engelse titel Hardmetals - Metallographic determination of microstructure - Part 2: Measurement of WC grain size
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen