Norm

NEN-EN-ISO 4759-3:2016 en

Toleranties voor bevestigingsartikelen - Deel 3: Onderlegringen voor bouten, schroeven en moeren - Productklassen A, C en F

52,53

Over deze norm

Status Definitief
Aantal pagina's 11
Commissie Onderdelen voor bevestiging
Gepubliceerd op 01-07-2016
Taal Engels
NEN-EN-ISO 4759-3 specifies tolerances for flat washers of product grades A, C and F with nominal diameters of 1 mm to 150 mm inclusive, designed to be used in bolted joints in combination with bolts, screws, studs and nuts. This part of ISO 4759 may be applied to non-flat washers however it does not include all the tolerances related to these washers. It applies to non-captive and captive washers, and to standard and non-standard washers. It does not apply to dynamic disc springs. Washers of product grades F and A are intended to be used with bolts, screws, studs and nuts of product grades A and B; washers of product grade C are intended to be used with bolts, screws, studs and nuts of product grade C.

Details

ICS-code 21.060.30
Nederlandse titel Toleranties voor bevestigingsartikelen - Deel 3: Onderlegringen voor bouten, schroeven en moeren - Productklassen A, C en F
Engelse titel Tolerances for fasteners - Part 3: Washers for bolts, screws and nuts - Product grades A, C and F
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen