Norm

NEN-EN-ISO 6145-8:2008 en

Gasanalyse - Bereiding van kalibratiegasmengsels met gebruik van dynamische volumetrische methoden - Deel 8: Diffusiemethode

106,87

Over deze norm

Status Definitief
Aantal pagina's 19
Commissie Gasanalyse
Gepubliceerd op 01-09-2008
Taal Engels
This part of ISO 6145 specifies a dynamic method using diffusion for the preparation of calibration gas mixtures containing component mole fractions ranging from 10 9 to 10 3. A relative expanded uncertainty of measurement, U, obtained by multiplying the relative combined standard uncertainty by a coverage factor k = 2, of not greater than 2 % can be achieved by using this method. By keeping the path between the diffusion source and place of use as short as possible, the method can be applied for the generation of low-concentration calibration gases of organic components that are liquid at room temperature, with boiling points ranging from about 40 °C to 160 °C. This part of ISO 6145 is applicable not only for the generation of calibration gas mixtures of a wide range of hydrocarbons at ambient and indoor air concentration levels, but also for the generation of low-concentration gas mixtures of water.

Details

ICS-code 71.040.40
Nederlandse titel Gasanalyse - Bereiding van kalibratiegasmengsels met gebruik van dynamische volumetrische methoden - Deel 8: Diffusiemethode
Engelse titel Gas analysis - Preparation of calibration gas mixtures using dynamic volumetric methods - Part 8: Diffusion method
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen