Norm

NEN-EN-ISO 6789-2:2017 en

Montagegereedschappen voor bouten en moeren - Met de hand bediende aandraaigereedschappen - Deel 2: Eisen voor kalibratie en bepaling van meetonzekerheden

143,10

Over deze norm

Status Definitief
Aantal pagina's 41
Commissie Gereedschappen
Gepubliceerd op 01-03-2017
Taal Engels
NEN-EN-ISO 6789-2 specifies the method for the calibration of hand torque tools and describes the method of calculation of measurement uncertainties for the calibration. This document specifies the minimum requirements for the calibration of the torque measurement device where the relative measurement uncertainty interval, W´md, is not already provided by a traceable calibration certificate. ISO 6789 is applicable for the step by step (static) and continuous (quasi-static) calibration of torque measurement devices, the torque of which is defined by measuring of the elastic form change of a deformable body or a measured variable which is in proportion to the torque. This document applies to hand torque tools which are classified as indicating torque tools (Type I) and setting torque tools (Type II).

Details

ICS-code 25.140.30
Nederlandse titel Montagegereedschappen voor bouten en moeren - Met de hand bediende aandraaigereedschappen - Deel 2: Eisen voor kalibratie en bepaling van meetonzekerheden
Engelse titel Assembly tools for screws and nuts - Hand torque tools - Part 2: Requirements for calibration and determination of measurement uncertainly
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen