Norm

NEN-EN-ISO 8662-11:1996 Ontw. en

Draagbare handgereedschappen met motoraandrijving - Meting van mechanische trillingen aan het handvat - Deel 11: Nietmachines

  • Deze norm is ingetrokken sinds 01-05-2004

25,62

Over deze norm

Status Ingetrokken
Aantal pagina's 13
Gepubliceerd op 01-08-1996
Taal Engels
Specifies a laboratory method for measuring the single event vibrations at the handle of fastener driving tools, such as nailers, staplers, pinners. It is a type test procedure for establishing the vibration value in the handle of a hand-held power tool operating under a specified load. For fastener driving tools covered by this part of ISO 8662, the power required for the driving can be received from compressed air, electricity, combustible gases in an internal combustion engine or from tension springs. Fastener driving tools may be actuated by single actuation, contact actuation or continuous actuation. Fasteners can be e.g. nails, staples, pins, corrugated fasteners, screws used as nails, dowels, sleeves, cable collars, base supports. The intention of this standard is that the results can be used to compare different models of the same power tool.

Details

ICS-code 13.160
25.140.10
25.140.99
Nederlandse titel Draagbare handgereedschappen met motoraandrijving - Meting van mechanische trillingen aan het handvat - Deel 11: Nietmachines
Engelse titel Hand-held portable power tools - Measurement of vibrations at the handle - Part 11: Fastener driving tools (nailers)
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen