Norm

NEN-ISO 10350-1:2007 en

Kunststoffen - Vaststelling en weergave van vergelijkbare eenpunts-gegevens - Deel 1: Pers- en spuitgietmaterialen

  • Deze norm is ingetrokken sinds 04-09-2008

52,53

Over deze norm

Status Ingetrokken
Aantal pagina's 10
Commissie Kunststoffen
Gepubliceerd op 01-07-2007
Taal Engels
ISO 10350 identifies specific test procedures for the acquisition and presentation of comparable data for certain basic properties of plastics. In general, each property is specified by a single experimental value, although in certain cases properties are represented by two values obtained under different test conditions. The properties included are those presented conventionally in manufacturers' data sheets. This part of ISO 10350 applies predominantly to unreinforced and reinforced thermoplastic and thermosetting materials that may be injection- or compression-moulded or prepared as sheets of specified thickness. Part 2 of ISO 10350 deals specifically with long- or continuous-fibre-reinforced plastics. For the purposes of ISO 10350, long-fibre-reinforced plastics are considered to have fibre lengths greater than 7,5 mm prior to moulding.

Details

ICS-code 83.080.20
Nederlandse titel Kunststoffen - Vaststelling en weergave van vergelijkbare eenpunts-gegevens - Deel 1: Pers- en spuitgietmaterialen
Engelse titel Plastics - Acquisition and presentation of comparable single-point data - Part 1: Moulding materials
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen