Norm

NEN-ISO 13041-7:2004 en

Gereedschapsmachines - Beproevingsvoorwaarden voor numeriek bestuurde draaimachines en draaicentra - Deel 8: Beoordeling van de contourprestaties in de drie coordinaatvlakken

31,57

Over deze norm

Status Definitief
Aantal pagina's 4
Commissie Gereedschappen
Gepubliceerd op 01-02-2004
Taal Engels
This part of the ISO 13041 describes a method of checking the contouring performance of turning centres (or numerically controlled turning) by conducting circular tests and by evaluating the radial deviation F and circular deviation G, in accordance with ISO 230-4. The concept of checks by circular tests described in this part of ISO 13041 is to verify the circular movement - only in one position per coordinate plane of the machine, - at only one feed rate, and - to repeat the test once in the opposite contouring direction. The purpose of this part of ISO 13041 is not to provide a means of analysing the causes for the measured circular deviations, but to offer the user a method for periodic checking of the machine tool. It is recommended to carry out the tests of this part of ISO 13041 after the machine tool has passed the acceptance tests and to use these results as a basis for comparison during periodic checks. Therefore acceptable deviations from the initial results have to be decided by the user. If the tests are used for machine acceptance purposes, the supplier/manufacturer and the user have to agree on specific diameters, feed rates and tolerances for the tests.

Details

ICS-code 25.040.20
Nederlandse titel Gereedschapsmachines - Beproevingsvoorwaarden voor numeriek bestuurde draaimachines en draaicentra - Deel 8: Beoordeling van de contourprestaties in de drie coordinaatvlakken
Engelse titel Test conditions for numerically controlled turning machines and turning centres - Part 7: Evaluation of contouring performance in the coordinate planes

Winkelwagen

Subtotaal:

Ga naar winkelwagen