Norm

NEN-ISO 13726:2008 en

Hydrauliek - Cilinders met enkele zuigerstang, 16 MPa (160 bar) compactreeks met boringen van 250 mm tot en met 500 mm - Afmetingen voor externe bevestingen

52,53

Over deze norm

Status Definitief
Aantal pagina's 7
Commissie Hydrauliek en pneumatiek
Gepubliceerd op 01-03-2008
Taal Engels
This International Standard specifies the mounting dimensions required for interchangeability of accessories for 16 MPa (160 bar) compact cylinders conforming to ISO 6020-3. The accessories have been designed specifically for use with cylinders manufactured in accordance with ISO 6020-3, but this does not limit their application. This International Standard covers the following accessories: - AP2 - rod clevis, female thread (see Figure 1 and Table 1); - AP4 - rod eye, plain, female thread (see Figure 2 and Table 2); - AA4;L - pivot pin (locking plate) (see Figure 3 and Table 3); - AL6 - locking plate for pivot pin (see Figure 4 and Table 4); - AA4;S - pivot pin plain (see Figure 5 and Table 5). These accessories are used on hydraulic cylinders for mechanically transmitting the cylinder force. The design of these accessories is based on the maximum forces resulting from the specified internal diameters of the cylinders and pressures according to ISO 2944 and ISO 3320.

Details

ICS-code 23.100.20
Nederlandse titel Hydrauliek - Cilinders met enkele zuigerstang, 16 MPa (160 bar) compactreeks met boringen van 250 mm tot en met 500 mm - Afmetingen voor externe bevestingen
Engelse titel Hydraulic fluid power - Single rod cylinders, 16 MPa (160 bar) compact series with bores from 250 mm to 500 mm - Accessory mounting dimensions
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen