Norm

NEN-ISO 17577:2006 en

Steel - Ultrasonic testing for steel flat products of thickness equal to or greater than 6 mm

  • Deze norm is ingetrokken sinds 07-05-2012

52,53

Over deze norm

Status Ingetrokken
Aantal pagina's 12
Gepubliceerd op 01-09-2006
Taal Engels
This International Standard specifies a method for the automated and/or manual ultrasonic testing of uncoated steel flat products for internal discontinuities by the reflection method. It is applicable to non-alloyed or alloyed steel flat products, in a nominal thickness range of 6 mm to 200 mm. However, this standard may be applied to austenitic and austenitic-ferritic steels, provided that the difference between the amplitude of the noise signal and that of the echo detection threshold is sufficient for the limit fixed. Unless otherwise agreed, for testing of steel flat products for welded steel tubes, ISO 12094 applies. Other methods of testing (e.g. by transmission) or other test equipment may be used at the manufacturer's discretion, provided that they give identical results to those obtained under the conditions of this standard. In the event of a dispute, only the method defined in this standard will prevail. Testing of flat products, of thickness less than 6 mm and over 200 mm, may be the subject of special agreements between the parties concerned. The inspection is normally carried out in the place of production or on the premises of the supplier.

Details

ICS-code 77.040.20
77.140.50
Nederlandse titel Steel - Ultrasonic testing for steel flat products of thickness equal to or greater than 6 mm
Engelse titel Steel - Ultrasonic testing for steel flat products of thickness equal to or greater than 6 mm
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen