Norm

NEN-ISO 19840:2005 en

Verven en vernissen - Corrosiebescherming van staalconstructies door beschermende verfsystemen op - Meetmethode en aanvaardingscriteria voor de droge laagdikte op ruwe oppervlakken

  • Deze norm is ingetrokken sinds 11-09-2012

73,12

Over deze norm

Status Ingetrokken
Aantal pagina's 15
Gepubliceerd op 01-05-2005
Taal Engels
This International Standard specifies a procedure for the verification of dry film thickness against nominal dry film thickness on rough surfaces, including the adjustment of the instruments used, the definition of inspection areas, sampling plans, measurement methods and acceptance/rejection criteria. For the purposes of this standard, any specified thickness is taken to be nominal as defined in ISO 12944-5 and the dry film thickness is the typical thickness above the peaks of the surface profile. The procedure described in this International Standard is based on the use of instruments of the permanent magnet and inductive magnet type. Instruments are adjusted to zero and a known thickness on a smooth surface. Measurements taken on a coating on a roughened steel substrate will therefore be higher than the actual value above the peaks of the profile. The thickness of the dry film above the peaks of the profile is defined as the instrument reading minus an appropriate correction value. The dry film thickness is obtained by using the appropriate correction value applied to readings based on adjustment on a smooth, flat, steel surface. Where individual readings, based on adjustment on a smooth, flat steel surface without the use of correction values, are specified or agreed, it is important to recognise that this method does not conform with this International Standard. This standard is applicable if the nominal dry film thickness is 40 ┬Ám or greater.

Details

ICS-code 87.020
Nederlandse titel Verven en vernissen - Corrosiebescherming van staalconstructies door beschermende verfsystemen op - Meetmethode en aanvaardingscriteria voor de droge laagdikte op ruwe oppervlakken
Engelse titel Paints and varnishes - Corrosion protection of steel structures by protective paint systems - Measurement of, and acceptance criteria for, the thickness of dry film on rough surfaces
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen