Norm

NEN-ISO 20457:2018 en

Kunststof spuitgietonderdelen - Toleranties en acceptatievoorwaarden

125,90 152,34 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 28
Commissie Kunststoffen
Gepubliceerd op 01-09-2018
Taal Engels
NEN-ISO 20457 specifies possible manufacturing tolerances for plastic moulded parts. This document specifies all integral features with general tolerances with surface profile tolerance within a specified datum system. It allows for additional specifications in case of functional needs and requirements using the ISO-GPS-tools for dimensional and geometrical tolerating. This document addresses injection moulding, injection compression moulding, transfer moulding, compression moulding and rotational moulding of non-porous moulded parts made from thermoplastics, thermoplastic elastomers and thermosets of thermoplastics. This document is applicable to other plastic processes if agreed to by the contractual parties. Moulded part surface imperfections such as sink marks, undesired flow structures and roughness, as well as joint lines are not addressed in this document. This document is not intended to supplant, replace or in any way interfere with requirements for tolerances found in product standards.

Details

ICS-code 83.140.01
Nederlandse titel Kunststof spuitgietonderdelen - Toleranties en acceptatievoorwaarden
Engelse titel Plastics moulded parts - Tolerances and acceptance conditions

Winkelwagen

Subtotaal:

Ga naar winkelwagen