Norm

NEN-ISO 21307:2018 en

Kunststof buizen en hulpstukken - Stuiklas afdichtingsprocedures voor polyetheen (PE) buizen en hulpstukken gebruikt in constructies van gas- en waterdistributiesystemen

79,70 96,44 Incl BTW

Over deze norm

Status Definitief
Aantal pagina's 16
Commissie Kunststofleidingsystemen voor gasvoorzieningen
Gepubliceerd op 01-01-2018
Taal Engels
NEN-ISO 21307 establishes general principles regarding the procedure used in the construction and quality assessment of butt fusion jointing of polyethylene (PE) piping system components specified in accordance with relevant ISO standards. These components are installed in accordance with the relevant codes of practice, national regulations or industry guidance. Specifically, this document specifies three butt fusion jointing procedures for PE pipes and fittings. These are: - single low-pressure fusion jointing procedure; - dual low-pressure fusion jointing procedure; - single high-pressure fusion jointing procedure. This document takes into consideration the materials and components used, the fusion jointing procedure and equipment and the quality assessment of the completed joint. It can be applied in conjunction with appropriate national regulations and standards.

Details

ICS-code 23.040.20
23.040.45
75.200
93.025
Nederlandse titel Kunststof buizen en hulpstukken - Stuiklas afdichtingsprocedures voor polyetheen (PE) buizen en hulpstukken gebruikt in constructies van gas- en waterdistributiesystemen
Engelse titel Plastics pipes and fittings - Butt fusion jointing procedures for polyethylene (PE) piping systems
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen