Norm

NEN-ISO 230-10:2011 en

Beproevingsprogramma voor gereedschapsmachines - Deel 10: Bepaling van de meetprestaties van aftastsystemen van numeriek bestuurde gereedschapswerktuigen

  • Deze norm is ingetrokken sinds 10-02-2016

143,10

Over deze norm

Status Ingetrokken
Aantal pagina's 38
Commissie Metaalbewerkingsmachines
Gepubliceerd op 01-05-2011
Taal Engels
This part of the IEC 60679 series applies to the phase jitter measurement of quartz crystal oscillators and SAW oscillators used for electronic devices and gives guidance for phase jitter that allows the accurate measurement of r.m.s. jitter. In the measurement method, phase noise measurement equipment or a phase noise measurement system is used. The measuring frequency range is from 10 MHz to1 000 MHz. This standard applies to quartz crystal oscillators and SAW oscillators used in electronic devices and modules that have the multiplication or division functions based on these oscillators. The type of phase jitter applied to these oscillators is the r.m.s. jitter. In the following text, these oscillators and modules will be referred to as “oscillator(s)” for simplicity.

Details

ICS-code 25.080.01
Nederlandse titel Beproevingsprogramma voor gereedschapsmachines - Deel 10: Bepaling van de meetprestaties van aftastsystemen van numeriek bestuurde gereedschapswerktuigen
Engelse titel Test code for machine tools - Part 10: Determination of the measuring performance of probing systems of numerically controlled machine tools
Vervangen door
Gewijzigd door

Winkelwagen

Subtotaal:

Ga naar winkelwagen