Norm

NEN-ISO 2493-2:2011 en

Papier en karton - Bepaling van de buigweerstand - Deel 2: Taber-type proef

52,53

Over deze norm

Status Definitief
Aantal pagina's 9
Gepubliceerd op 01-11-2011
Taal Engels
This part of ISO 2493 specifies procedures to measure the bending resistance of paper and paperboard. This part of ISO 2493 is used to determine the bending moment required to deflect the free end of a 38 mm wide vertically clamped specimen by 15° when the load is applied at a bending length of 50 mm. For boards that tend to be permanently deformed if bent through 15°, the half bending angle, i.e. 7,5°, can be used. The bending resistance is expressed in terms of the bending moment and parameters set by the manufacturer of the Taber-type tester. The method is primarily used for papers with a high grammage.

Details

ICS-code 85.060
Nederlandse titel Papier en karton - Bepaling van de buigweerstand - Deel 2: Taber-type proef
Engelse titel Paper and board - Determination of bending resistance - Part 2: Taber-type tester
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen