Norm

NEN-ISO 3338-2:2007 en

Cilindrische schachten voor frezen - Deel 2: Dimensionele karakteristieken van cilindrische schachten met één of twee platte vlakken

  • Deze norm is ingetrokken sinds 14-08-2013

34,42

Over deze norm

Status Ingetrokken
Aantal pagina's 4
Commissie Gereedschappen
Gepubliceerd op 15-02-2007
Taal Engels
This part of ISO 3338 specifies the dimensions of flatted cylindrical shanks for milling cutters - of diameters to for single-flatted shanks, to for double-flatted shanks and to for shanks with an inclined clamping surface. In the case of single-flatted shanks, it is applicable to both singleended cutters and double-ended cutters, as double-flatted shanks cannot admit single-ended cutters. The dimensions of plain cylindrical shanks and threaded shanks are given in ISO 3338-1 and ISO 3338-3, respectively. The two shank types covered by ISO 3338-1 and this part of ISO 3338 have the same dimensional characteristics (diameters and lengths) but different tolerances on diameters, namely: - h8 for plain cylindrical shanks, commonly used for tools mounted in collets; - h6 for flatted cylindrical shanks, intended to be mounted in chucks and secured with a clamping screw, and requiring an accuracy adjustment.

Details

ICS-code 25.100.20
Nederlandse titel Cilindrische schachten voor frezen - Deel 2: Dimensionele karakteristieken van cilindrische schachten met één of twee platte vlakken
Engelse titel Cylindrical shanks for milling cutters - Part 2: Dimensional characteristics of flatted cylindrical shanks

Winkelwagen

Subtotaal:

Ga naar winkelwagen