Norm

NEN-ISO 5350-4:2006 en

Celstoffen - Bepaling van vuil en vezelbundels - Deel 4: Instrumentele inspectie door reflecterend licht bij gebruik van Equivalente Zwarte Ruimte (EBA) methode

52,53

Over deze norm

Status Definitief
Aantal pagina's 10
Gepubliceerd op 01-09-2006
Taal Engels
This part of ISO 5350 specifies a method using instrumental inspection by reflected light for the estimation of visible dirt and shives in pulp manufactured in sheets, in terms of Equivalent Black Area (EBA) of dirt specks within the physical area range of to . Using the algorithm prescribed in this part of ISO 5350, the maximum dirt size is limited to . Extension to other speck sizes (for example, those greater than in physical area) may require changes in equipment, calculation procedures, or both, and is not covered in this part of ISO 5350. This part of ISO 5350 cannot be used for physical area measurements, since it may not correctly measure the dirt specks for that mode of measurement. The specimen to be evaluated should have a brightness, as determined by ISO 3688, of or greater. It may be necessary to reform some pulp sheets into laboratory sheets, if the surface is too rough or textured. This part of ISO 5350 is also intended for recycled pulp. 0,02 mm2 3,0 mm2 3,0 mm2 3,0 mm2 30 %.

Details

ICS-code 85.040
Nederlandse titel Celstoffen - Bepaling van vuil en vezelbundels - Deel 4: Instrumentele inspectie door reflecterend licht bij gebruik van Equivalente Zwarte Ruimte (EBA) methode
Engelse titel Pulps - Estimation of dirt and shives - Part 4: Instrumental inspection by reflected light using Equivalent Black Area (EBA) method
Vervangt

Winkelwagen

Subtotaal:

Ga naar winkelwagen