Norm

NEN-ISO 5458:1994 Ontw. en

Technische tekeningen - Geometrische toleranties - Plaatstoleranties

  • Deze norm is ingetrokken sinds 30-06-1999

17,55

Over deze norm

Status Ingetrokken
Aantal pagina's 8
Commissie Productgeometrie
Gepubliceerd op 01-07-1994
Taal Engels
This standard describes the principle of positional tolerancing for the location of regular and irregular features. However for clarity, only regular-shaped features such as holes, bolts, studs or pins, parallel-sided slots, keys and keyways have been shown. Positional tolerancing may also be applied to the location of a point, a straight line, or a plane surface. However, profile tolerancing must be used when lines are not intended to be straight or surfaces are not intended to lie in a plane, see ISO 1660.

Details

ICS-code 01.100.20
Nederlandse titel Technische tekeningen - Geometrische toleranties - Plaatstoleranties
Engelse titel Technical drawings - Geometrical tolerancing - Positional tolerancing
Vervangt
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen