Norm

NEN-ISO 8513:2014 en

Kunststofleidingsystemen - Glasvezel versterkte thermoharde kunststof (GVK) buizen - Beproevingsmethoden voor de bepaling van de schijnbare initiƫle treksterkte in de lengterichting

  • Deze norm is ingetrokken sinds 08-02-2016

79,70

Over deze norm

Status Ingetrokken
Aantal pagina's 16
Commissie Kunststofleidingsystemen
Gepubliceerd op 01-05-2014
Taal Engels
NEN-ISO 8513 specifies three test methods for determining the longitudinal tensile properties of glass-reinforced thermosetting plastics (GRP) pipes. The properties which can be determined are - the longitudinal tensile strength and - the percentage ultimate elongation. Method A uses, for the test piece(s), a longitudinal strip cut from a pipe. Method B uses a specified length of the full cross-section of the pipe. Method C uses a notched plate cut from a pipe wall section. Method A is applicable to pipes with a nominal size of DN 50 or greater with circumferentially wound filaments, with or without chopped glass and/or woven rovings and/or fillers, and to centrifugally cast pipes. It is applicable to pipes with helically wound filaments with a nominal size of DN 200 or greater. Method B is applicable to all types of GRP pipe. It is usually used for pipes with a nominal size up to and including DN 150. Method C is primarily intended for use for helically wound pipes with a winding angle other than approximately 90°. This method can also be used for other types of pipe. Results from one method are not necessarily equal to the results derived from any of the alternative methods. However, all methods have equal validity. Annex A describes additional considerations for method B that have been found useful for the testing of thin-walled helically wound pipes and can be used to supplement the basic text.

Details

ICS-code 23.040.20
Nederlandse titel Kunststofleidingsystemen - Glasvezel versterkte thermoharde kunststof (GVK) buizen - Beproevingsmethoden voor de bepaling van de schijnbare initiƫle treksterkte in de lengterichting
Engelse titel Plastics piping systems - Glass-reinforced thermosetting plastics (GRP) pipes - Test methods for the determination of the apparent initial longitudinal tensile strength
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen