Norm

NPR-CEN/TS 16637-2:2014 en

Bouwproducten - Beoordeling van het vrijkomen van gevaarlijke stoffen - Deel 2: Horizontale methode voor het bepalen van de dynamische oppervlak-uitloging

86,00

Over deze norm

Status Definitief
Aantal pagina's 58
Commissie Schaduwgroep CEN/TC 351 'Construction products: Assessment of release of dangerous substances'
Gepubliceerd op 01-09-2014
Taal Engels
NPR-CEN/TS 16637-2 specifies a Dynamic Surface Leaching Test (DSLT) which is aimed at determining the release per unit surface area as a function of time of inorganic and/or non-volatile organic substances from a monolithic, plate- or sheet-like product, when it is put into contact with an aqueous solution (leachant). The test method is not suitable for substances that are volatile under ambient conditions. (2) This test is a parameter specific test focusing on identifying and specifying parameter specific properties tested under specified conditions. It is not aimed at simulating real situations. The application of results to specific intended conditions of use may be established by means of modelling (not included in this Technical Specification). (3) The modification for granular construction products with low hydraulic conductivity (Annex A) applies for granular particles with so little drainage capacity between the grains that percolation in percolation tests and in practice is nearly impossible. (4) The test method applies to more or less regularly shaped test portions consisting of monolithic test pieces with minimum dimensions of 40 mm in all directions (volume > 64 000 mm3 (64 cm3)). It also applies to plate- or sheet-like products with surface areas of minimum 10 000 mm2 (100 cm2) exposed to the leachant. Products designed to drain water (e.g. draining tiles, porous asphalt) and monolithic granular products according to CEN/TS 16637-1:2014, Table 1, are also tested by this test method. All products to be tested are assumed to maintain their integrity over a time frame relevant for the considered intended use. (5) Metals, metallic coatings and organic coatings on metals are excluded from the scope of CEN/TS 16637-2 because the principles of this test (diffusion) are not obeyed by these products. Guidance on the need for testing of these products is under consideration. (6) For some coatings (e.g. some renders with organic binders according to EN 15824) in intermittent contact to water, physical and chemical properties might be changed in permanent contact with water. For these products CEN/TS 16637-2 is not appropriate. (7) Guidance on the applicability of the test method to a given product is outlined in CEN/TS 16637-1.

Details

ICS-code 13.040.20
19.040
91.100.01
Nederlandse titel Bouwproducten - Beoordeling van het vrijkomen van gevaarlijke stoffen - Deel 2: Horizontale methode voor het bepalen van de dynamische oppervlak-uitloging
Engelse titel Construction products - Assessment of release of dangerous substances - Part 2: Horizontal dynamic surface leaching test
Normatieve verwijzingen
  • 89/106/EEG, Bouwproducten

Winkelwagen

Subtotaal:

Ga naar winkelwagen