Norm

NPR-IEC/PAS 61338-1-5:2010 en

Diëlektrische resonators van het golfgeleidertype - Deel 1-5: Algemene informatie en beproevingsomstandigheden - Methode voor het meten van de geleiding bij de interface tussen geleiderlagen en diëlektrische substraat bij ultrahoge frequentie

  • Deze norm is ingetrokken sinds 24-09-2015

90,57

Over deze norm

Status Ingetrokken
Aantal pagina's 20
Gepubliceerd op 01-06-2010
Taal Engels
Microwave circuits are popularly formed on multi-layered organic or non-organic substrates. In the microwave circuits, the attenuation of planar transmission lines such as striplines, microstrip lines, and coplanar lines are determined by their conductor loss, dielectric loss and radiation loss. Among them, the conductor loss is a major factor in the attenuation of the planar transmission lines. A new measurement method is needed to evaluate the conductivity of transmission line on or in the substrates such as the organic, ceramic and LTCC (low temperature co-fired ceramics) substrates. The IEC 61338-1-3 described the measurement method for the surface resistance Rs and effective conductivity s on the surface of the conductor. The term s is designated as s s in this PAS, and is called surface conductivity (Figure 1). This PAS describes a measurement method for resistance and effective conductivity at the interface between conductor layer and dielectric substrate designated as i R and i s respectively, and are called interface resistance and interface conductivity. For the transmission line in the substrates, the electric current is concentrated at the interface between conductor layer and dielectric substrate, because the skin depth δ in the conductor is the order of μm in thickness at the microwave frequencies. In microstrip lines, the current is concentrated at the interface, rather than at the open face of the conductor. Furthermore, in copper-clad organic substrates, the interface side of the copper foil has rugged structure to hold the strong adhesive strength. In LTCC substrates, the interface between the conductor and ceramics has a rough structure, depending on the co-firing process and the material compositions. The interface conditions increase the conductor loss. Therefore, the evaluation of i R and i s is important to design microwave circuit and to improve the conductor fabrication process. This measurement method has the following characteristics: - the interface resistance Ri is obtained by measuring the resonant frequency f0 and unloaded quality factor Qu of a TE01δ mode dielectric rod resonator shown in Figure 2; - the interface conductivity i s and the relative interface conductivity s ri =s i s 0 are calculated from the measured Ri value, where 5,8 107 S/m s 0 = × is the conductivity of standard copper; - the measurement uncertainty of s ri ( Δs ri ) is less than 5%.

Details

ICS-code 31.140
Nederlandse titel Diëlektrische resonators van het golfgeleidertype - Deel 1-5: Algemene informatie en beproevingsomstandigheden - Methode voor het meten van de geleiding bij de interface tussen geleiderlagen en diëlektrische substraat bij ultrahoge frequentie
Engelse titel Waveguide type dielectric resonators - Part 1-5: General information and test conditions - Measurement method of conductivity at interface between conductor layer and dielectric substrate at microwave frequency
Vervangen door

Winkelwagen

Subtotaal:

Ga naar winkelwagen