Norm

NVN-ISO/TS 13399-71:2016 en

Gegevensweergave en -uitwisseling van snijgereedschappen - Deel 71: Grafische gegevensopmaak - Opstellen van gestandaardiseerde documenten voor gegevensuitwisseling: Productinformatie in grafische vormĀ 

52,53

Over deze norm

Status Definitief
Aantal pagina's 8
Commissie Gereedschappen
Gepubliceerd op 01-07-2016
Taal Engels
NVN-ISO/TS 13399-71 determines the elements to be used for the creation of 2D documentation. The individual parts of documentation are drawing content, geometrical data, drawing frame and drawing header data as shown in Figure 1. The standardization of drawing formats, e.g. drawing frame, structure of the bill of material, are out of the scope of this part of ISO/TS 13399. Furthermore, it is intended to standardize the data exchange of the product documentation. This part of ISO/TS 13399 specifies a common way for the basic principles for the creation of product documentation that contain the following: - definitions and identifications of the elements of a product documentation; - definitions and identifications of the internal structure of the product documentation; - definitions and identifications of those elements and features that are necessary to show the protection notices and the copyrights of the originator of the document.

Details

ICS-code 25.100.01
35.240.50
Nederlandse titel Gegevensweergave en -uitwisseling van snijgereedschappen - Deel 71: Grafische gegevensopmaak - Opstellen van gestandaardiseerde documenten voor gegevensuitwisseling: Productinformatie in grafische vormĀ 
Engelse titel Cutting tool data representation and exchange - Part 71: Graphical data layout - Creation of documents for standardized data exchange: Graphical product information

Winkelwagen

Subtotaal:

Ga naar winkelwagen